first image

Add Note Edit Step 4  ¶ 

  • Insert an iPod opening tool between the outer case and the display retainer.

  • Use the tool to slide the display assembly out of the case slightly.

  • Do not rotate the display retainer about the top edge of the display, as it is attached to a thin steel bracket that is easily broken.

  • Do not forcefully remove the display retainer, as the hold switch cable is liable to snap.

first image

Add Note Edit Step 5  ¶ 

  • Slide the display out of the Nano. It will move about .5" until the display data cable limits its travel.

  • Do not put unnecessary tension on the very thin display data cable.

first image
thumb image 1
thumb image 2

Add Note Edit Step 6  ¶ 

  • With the display pulled out of the case as much as possible, press the lower edge of the glass panel gently toward the lower rear edge of the nano.

  • The lower edge of the glass panel will slide slightly down and into the case as the top edge pops up out of the case.

Next » « Previous

Comments Add Note Comments are offturn on