Installing iPod Nano 4th Generation Glass Panel

  • Add Note x
  • x 19

Did your Nano take a spill? Use this guide to replace its curved glass panel.

Tools
Relevant parts
first image
thumb image 1
thumb image 2

Add Note Edit Step 1 — Glass Panel  ¶ 

  • Insert the edge of an iPod opening tool into the gap between the outer case and the top bezel.

  • Pry the top bezel off the adhesive securing it to the display retainer.

  • At this point the hold switch slider is free and may fall. Be careful not to lose it.

first image

Add Note Edit Step 2  ¶ 

  • Remove the hold switch slider from the top of the Nano.

first image

Add Note Edit Step 3  ¶ 

  • Remove the two angled Phillips screws from the two corners of the display retainer.

  • These screw heads are extremely small and easily stripped.

Next » « Previous

Comments Add Note Comments are offturn on