first image

Add Note Edit Step 34  ¶ 

  • Lift the logic board out of the rear case, minding any cables that may get caught.

  • If the front edge of the logic board, under the RAM sockets, won't pull up, it's sticking on the three plastic mounting pins in the rear housing under this edge. Use a spudger under the front edge of the RAM sockets to gently push up on this edge until it clears these mounting pins.

first image

Add Note Edit Step 35 — Video Card  ¶ 

  • Disconnect the video card thermal sensor by pulling its connector away from the socket on the logic board.

  • Pull the connector parallel to the face of the logic board.

first image

Add Note Edit Step 36  ¶ 

  • Remove the two 5 mm T8 Torx screws securing the video card to the framework on the logic board.

Next » « Previous

Comments Add Note Comments are offturn on