Installing iMac Intel 20" EMC 2133 and 2210 Optical Drive

Prerequisite Only

Prerequisite Only

This guide is only used as a prerequisite for other guides and is not a complete or useful guide when viewed independently.

  • Add Note x
first image

Add Note Edit Step 1 — Optical Drive  ¶ 

  • If necessary, remove the pieces of tape securing the hard drive/optical drive thermal sensor cables to your iMac.

first image

Add Note Edit Step 2  ¶ 

  • Disconnect the optical drive thermal sensor connector from the logic board by pulling its connector toward the top of your iMac.

  • When removing this connector, it is helpful use your thumbnails to push the ears on either side of the connector toward the top of your iMac.

first image

Add Note Edit Step 3  ¶ 

  • Remove the two fine-thread 7 mm T10 Torx screws securing the optical drive to the rear case.

Next » « Previous

Comments Add Note Comments are offturn on