first image

Add Note Edit Step 25  ¶ 

  • Disconnect the DC-In cable from the logic board.

first image

Add Note Edit Step 26  ¶ 

  • Deroute the cable from around the optical drive, removing tape as necessary, and angle the DC-In board out of its compartment.

first image

Add Note Edit Step 27 — Upper Case  ¶ 

  • Remove the following 11 screws from the bottom of the computer:

    • Three 3 mm Phillips around the battery compartment. (Some models may only have two screws.)

    • Three 4.5 mm Phillips along the optical drive bezel. (a magnetic screwdriver may help to lift these screws out)

    • One 11 mm Phillips in the lower right corner. (if present)

    • Four 14.5 mm Phillips.

Next » « Previous

Comments Add Note Comments are offturn on