iFixit

Insert the flat end of a spudger between the rear display bezel and the clutch cover.

Twist the spudger to unclip the rear bezel from the clutch cover.

Repeat the previous steps to separate the right side of the rear display bezel from the display.

Use your spudger to pry the plastic retaining clips on the rear display bezel over the raised aluminum tabs on the front display bezel.

At this point, the clips on the left and right edges of the rear display bezel should be free from the raised aluminum tabs on the front display bezel. If they are not, use a spudger to pry them past the front display bezel.

Slightly lift the lower edge of the rear display bezel and push it toward the top edge of the display, releasing the clips along the top edge of the rear display bezel.

Rotate the rear display bezel toward yourself and lay it flat on the table.

Lift the antenna board out of the clutch cover.

Peel back the three edges of the antenna board cover and remove it from over the antenna board.

Use the flat end of a spudger to pry both antenna connectors up off the antenna board.

The black antenna connects near the center of the antenna board.

If necessary, remove the two pieces of tape covering the inverter leads.

The inverter is an extremely thin circuit board that is very delicate and easily cracked. Take care when handling.

Use a spudger to raise the end of the inverter out from the clutch cover.

Lift the inverter enough to access both cable connectors.