first image

Add Note Edit Step 4 — Trigger buttons  ¶ 

  • The top cover will most likely come off during the repair, so might as well take it off now. Pull it upwards gently from its housing.

first image

Add Note Edit Step 5  ¶ 

  • The procedure is exactly the same for the left trigger button.

  • Use a PSP opening tool to gently flip up the left trigger connector.

first image
thumb image 1
thumb image 2

Add Note Edit Step 6  ¶ 

  • Unscrew the lone Phillips screw holding the trigger in place. Remove both trigger and retaining plate from the PSP Go.

  • If necessary, repeat steps 2 and 3 to remove the right trigger button.

Next » « Previous

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PSP Go device page.

Did you successfully follow this guide?

This guide has been completed 0 times.

Comments Add Note Comments are offturn on