Installing PSP Go Back Cover

This guide shows you how to remove the PSP Go's back cover.

Tools
Relevant Parts
Image #1 Image #2

Add Note Edit Step 1 — Back Cover  ¶ 

  • Unscrew the four Phillips screws on the back of the PSP Go.

  • Rotate the PSP so you can see the top of the device.

  • Unscrew the two Phillips screws next to the volume buttons.

Image #1 Image #2

Add Note Edit Step 2  ¶ 

  • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

  • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

  • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PSP Go device page.

Required Tools

Phillips #00 Screwdriver

$4.95 · 50+ In stock

Plastic Opening Tools

$2.95 · 50+ In stock

Related Products

Sony PSP Go Back Cover

$14.95

Recommended Tools

Universal Drive Adapter

$29.95 · 50+ In stock

Inspection Scope

$39.95 · 17 In stock

Frictionless Ratchet

$24.95

Portable Anti-Static Mat

$24.95 · 10 In stock

Comments Add Note Comments are offturn on