first image

Add Note Edit Step 4 — Rear Vent  ¶ 

  • Remove the following screws from the optical drive side of the rear vent:

    • Two 10 mm T8 Torx

    • Two 5 mm Phillips

first image

Add Note Edit Step 5  ¶ 

  • Remove the following screws from the port side of rear vent:

    • Two 10 mm T8 Torx

    • Two 5 mm Phillips

first image

Add Note Edit Step 6  ¶ 

  • Carefully lift the rear vent out of the upper case.

Next » « Previous

To reassemble your device, follow these instructions in reverse order.

For more information, check out the MacBook Unibody Model A1342 device page.

Did you successfully follow this guide?

This guide has been completed 3 times.

Comments Add Note Comments are offturn on