first image

Add Note Edit Step 22  ¶ 

  • Remove the following eight screws securing the logic board and DC-In board to the upper case:

    • Six 3.2 mm Phillips screws

    • Two 7.6 mm Phillips screws

first image
thumb image 1
thumb image 2

Add Note Edit Step 23  ¶ 

  • Handle the logic board by its edges only.

  • Lift the logic board from the side nearest the optical drive and lift it away from the upper case.

  • Carefully pull the ports and DC-In board away from the side of the upper case and remove the logic board, minding any cables that may get caught.

first image

Add Note Edit Step 24 — Heat Sink  ¶ 

  • Remove the eight 8.3 mm Phillips screws securing the heat sink to the logic board.

  • Be sure to keep track of the springs held under each of the screws.

Next » « Previous

Comments Add Note Comments are offturn on