Installing MacBook Pro 17" Unibody Battery

Replace a worn-out battery on your MacBook Pro 17" Unibody.

  • Add Note x
  • x 6

Use this guide to replace your MacBook Pro's battery. Removing the battery requires a Tri-wing screwdriver.

Sections
Tools
Relevant parts
first image

Add Note Edit Step 1 — Lower Case  ¶ 

  • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm Phillips screws.

    • Seven 3 mm Phillips screws.

first image
thumb image 1
thumb image 2

Add Note Edit Step 2  ¶ 

  • Wedge your fingers between the lower case and the vent, and lift upward to release the clips holding the lower case to the upper case.

  • Remove the lower case.

first image
thumb image 1
thumb image 2

Add Note Edit Step 3 — Battery  ¶ 

  • Whenever working near the logic board, it is always wise to first disconnect the battery to avoid short circuits.

  • Grab the plastic tab attached to the battery connector and pull it toward the front edge of the device.

  • Pull the tab parallel to the face of the logic board.

Next » « Previous

Comments Add Note Comments are offturn on