Installing MacBook Pro 15" Unibody Late 2011 Microphone

Restore recording capability by replacing the microphone on your Late 2011 MacBook Pro 15" Unibody.

  • Add Note x

Replacing the microphone requires removal of the logic board.

Sections
Tools
Relevant parts
first image

Add Note Edit Step 1 — Lower Case  ¶ 

  • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm (14.1 mm) Phillips screws.

    • Seven 3 mm Phillips screws.

first image

Add Note Edit Step 2  ¶ 

  • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

  • Remove the lower case and set it aside.

first image
thumb image 1
thumb image 2

Add Note Edit Step 3 — Battery Connector  ¶ 

  • For certain repairs (e.g. hard drive), disconnecting the battery connector is not necessary but it prevents any accidental shorting of electronics on the motherboard. If you do not disconnect the battery connector, please be careful as parts of the motherboard might be electrified.

  • Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.

  • It is useful to pry upward on both short sides of the connector to "walk" it out of its socket.

Next » « Previous

Comments Add Note Comments are offturn on