Installing MacBook Pro 15" Unibody Late 2008 and Early 2009 DC-In Board

  • Add Note x
  • x 5

No power to the laptop? Replace the DC-In Board.

Sections
Tools
Relevant parts
first image
thumb image 1
thumb image 2

Add Note Edit Step 1 — Access Door  ¶ 

  • With the case closed, place the Unibody top-side down on a flat surface.

  • Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.

first image

Add Note Edit Step 2  ¶ 

  • The access door should now be raised enough to lift it up and out of the Unibody.

first image

Add Note Edit Step 3 — Battery  ¶ 

  • Be sure the access door release latch is vertical before proceeding.

  • Grab the translucent plastic tab and pull the battery up and out of the Unibody.

  • If the latch is depressed it will lock the battery in place.

Next » « Previous

Comments Add Note Comments are offturn on