first image

Add Note Edit Step 4  ¶ 

  • Remove the following 6 screws:

    • Two 10 mm T6 Torx screws on either side of the RAM slot.

    • Four 14.5 mm Phillips screws along the hinge.

first image

Add Note Edit Step 5  ¶ 

  • Remove the four 3.2 mm Phillips screws on the port side of the computer.

first image

Add Note Edit Step 6  ¶ 

  • Rotate the computer 90 degrees and remove the two 3.2 mm Phillips screws from the rear of the computer.

Next » « Previous

Comments Add Note Comments are offturn on