Installing MacBook Pro 15" Core 2 Duo Model A1211 Left Ambient Light Sensor

  • Author: iRobot
  • Difficulty: Difficult

This detects the light level in the room to adjust the backlit keyboard.

Sections
Tools
Tools (continued)
Relevant Parts
Image #1

Add Note Edit Step 1 — Battery  ¶ 

  • Use your fingers to push both battery release tabs away from the battery, and lift the battery out of the computer.

Image #1

Add Note Edit Step 2 — RAM Shield  ¶ 

  • Remove the three identical Phillips screws from the memory door.

Image #1

Add Note Edit Step 3  ¶ 

  • Lift the memory door up enough to get a grip on it, and slide it toward you, pulling it away from the casing.

Image #1

Add Note Edit Step 4 — Upper Case  ¶ 

  • Remove the two 2.8 mm Phillips screws in the battery compartment near the latch.

Image #1

Add Note Edit Step 5  ¶ 

  • Remove the following 6 screws:

    • Two 10 mm T6 Torx screws on either side of the RAM slot.

    • Four 14.5 mm Phillips screws along the hinge.

Image #1

Add Note Edit Step 6  ¶ 

  • Remove the four 3.2 mm Phillips screws on the port side of the computer.

Image #1

Add Note Edit Step 7  ¶ 

  • Rotate the computer 90 degrees and remove the two 3.2 mm Phillips screws from the rear of the computer.

Image #1

Add Note Edit Step 8  ¶ 

  • Rotate the computer 90 degrees again and remove the four 3.2 mm Phillips screws from the side of the computer.

Next » « Previous

Required Tools

Spudger

$2.95 · 50+ In stock

T6 Torx Screwdriver

$4.95 · 50+ In stock

Phillips #00 Screwdriver

$4.95 · 50+ In stock

Related Products

MacBook Pro 15" (Models A1211/A1226) Left Ambient Light...

$29.95 · 40 In stock

Recommended Tools

Universal Drive Adaptor

$29.95 · 50+ In stock

iFixit Lock Pick Set

$29.95 · 17 In stock

Inspection Scope

$39.95 · 38 In stock

Frictionless Ratchet

$24.95 · 48 In stock

Portable Anti-Static Mat

$24.95 · 16 In stock

Comments Add Note Comments are offturn on