first image

Add Note Edit Step 10  ¶ 

  • Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.

  • Remove the upper case.

first image

Add Note Edit Step 11 — Hard Drive  ¶ 

  • Disconnect the orange hard drive ribbon cable from the logic board.

first image

Add Note Edit Step 12  ¶ 

  • Use a spudger to carefully loosen the adhesive securing the sleep light and IR sensor connectors to the top of the hard drive.

  • The entire ribbon cable may be glued to the hard drive. In that case, just carefully pry it up bit by bit with a spudger.

Next » « Previous

Comments Add Note Comments are offturn on