Installing MacBook Pro 13" Unibody Mid 2009 Heat Sink

  • Add Note x
  • x 4

The heat sink helps keep the processor cool and happy.

Sections
Tools
Tools (continued)
Relevant parts
first image

Add Note Edit Step 1 — Lower Case  ¶ 

  • Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

first image

Add Note Edit Step 2  ¶ 

  • Slightly lift the lower case and push it toward the rear of the computer to free the mounting tabs.

first image

Add Note Edit Step 3 — Battery  ¶ 

  • For precautionary purposes, we advise that you disconnect the battery connector from the logic board to avoid any electrical discharge. This step is optional and is not required.

  • Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

Next » « Previous

Comments Add Note Comments are offturn on