Installing Mac Mini Mid 2010 Logic Board

Prerequisite Only

Prerequisite Only

This guide is only used as a prerequisite for other guides and is not a complete or useful guide when viewed independently.

Prerequisite only.

  • Add Note x

Prerequisite only.

first image

Add Note Edit Step 1 — Logic Board  ¶ 

  • Remove the following three screws:

    • One 5.0 mm T8 Torx or 2.0 mm Hex screw (either will work)

    • One 16.2 mm T6 Torx screw

    • One 26 mm T6 Torx standoff

first image
thumb image 1
thumb image 2

Add Note Edit Step 2  ¶ 

  • Carefully pull the wires for both hard drive thermal sensors upward to lift their connectors up and out of the sockets on the logic board.

first image
thumb image 1
thumb image 2

Add Note Edit Step 3  ¶ 

  • Use the flat end of a spudger to pry both the hard drive and optical drive connectors up out of their sockets on the logic board.

Next » « Previous

Comments Add Note Comments are offturn on