Installing iMac Intel 27" EMC 2309 and 2374 Glass Panel

iMac Intel 27" EMC 2309 and 2374 Glass Panel replacement.

Remove the glass front panel to access the display and the rest of your iMac's internals.

Image #1

Edit Step 1 Glass Panel  ¶ 

  • Stick a suction cup near each of the two top corners of the glass panel.

  • To attach the suction cups we sell, first position the suction cup with the movable handle parallel to the face of the glass panel (as highlighted in the second picture).

  • While lightly holding the suction cup against the glass, raise the movable handle until it is parallel with the other handle (as highlighted by the third picture).

  • If your suction cups refuse to stick, try cleaning both the glass panel and the suction cup with a damp soft, lint-free cloth. (Dampen with distilled water, and if needed, an equal ratio of distilled water and white vinegar for best results.)

  • Do not use the suction cups to carry the display glass.

  • The original iMac box makes a good place to store the glass panel.

Image #1

Edit Step 2  ¶ 

  • Gently lift the glass panel perpendicular to the face of the LCD enough to clear the steel mounting pins attached along the underside of the top edge of the glass panel.

  • Pull the glass panel away from the lower edge of the iMac and carefully set it aside.

  • During reinstallation, be sure to meticulously clean the inside of the glass panel and the face of the LCD as any dust or fingerprints trapped inside will be annoyingly visible when the machine is turned on.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the iMac Intel 27" EMC 2309 and 2374 device page.

Required Tools

Heavy-Duty Suction Cups (Pair)

$14.95 · 50+ In stock

Popular Products

iPhone 4S Replacement Battery

$24.95 · 10 In stock

Spudger

$2.95 · 50+ In stock

Tweezers

$2.95 · 50+ In stock

54 Bit Driver Kit

$24.95 · 50+ In stock

TR8 Torx Security Screwdriver

$4.95 · 50+ In stock

Comments Comments are onturn off

You can easily lift the glass panel off the magnets with only your fingernails (or something thin like a credit card or a guitar pick). No need to buy suction cups you will only use once.

Nick Caron, · Reply

Yes, you don't need the specific suction cups to remove the display cover - it's held on by magnets, and if you start at the center by the iSight you can work out to the edges and remove it. I had an iPhone screen suction cup around and it helped with balancing the screen when you pull it out fully, but by no ways is it required.

jtowner, · Reply

Great guide and pretty straight forward the only thing that took me ages and I didn't manage to undo were the power btn cable (step 28) and the thermal sensor (step 25) Seemed like they were glued on! Very difficult to remove and obviously conscious so I didn't break anything!

Eddie, · Reply

Thanks!!! Worked excellently.

I used a plunger (clean first ;-) to get the screen off, and http://exirion.net/ssdfanctrl/ for fan control.

Then, i did not take out the whole display and left it in the hinges on the bottom side and held it up with two small cardboard boxes. Easy enough to disconnect the hdd then.

I replaced with an ssd, put that into a ssd enclosure. Had to drill an extra hole in it to fasten the pins that hold it in place.

Used Carbon Copy Cloner to make an image from the old hdd, with the sad connected via usb. Checked it of it booted via System Preferences > Startup Disk. It worked so the took the imac apart and replaced the disk. Booted, everything was working as always, only faster!

Frank303, · Reply

I'm replacing my optical drive too. what exactly needs to be plugged into the SSD? I don't have the kit - as I am not sure one is required if I buy something like this: http://www.amazon.com/gp/product/B0056OB...

Can you please advise? Can I do it with this piece, or do I need to get the entire bracket kit?

Allen Borza,

you should do this mac up, because, for me, one of the suction cup failed, and the glass fall into the lcd screen. Now there is a big hole in it...

Lau, · Reply

View Statistics:

Today: 4

This Week: 4

This Month: 346

All Time: 74,292