Lie phone screen down on a flat smooth surface so that the camera, logos, and speaker face up.

Using the provided notch on the bottom of the back cover, insert a prybar and lift upwards to remove the back cover of the phone.

Lie the cover beside the phone upon removal. Your assembly should appear as shown this far.

Insert the prybar into the crevice between the camera and the battery of the phone. Using a gentle prying motion, lift the end of the battery and remove.

After removal, recycle the defective battery appropriately. Take the replacement battery and lie it near the phone as shown. Your assembly should resemble the presented picture. Note that the cover is not included in this particular photo.

After removing the battery, insert the memory card into the lower left slot as designated by the circle in the picture. Be sure to have the contacts aligned into their appropriate slots.