Installing MacBook Pro 17" Models A1151 A1212 A1229 and A1261 Left Fan

  • Author: iRobot
  • Difficulty: Difficult
  • Add Note x
  • x 46

Replacing a defective fan is pretty easy and will keep your laptop running cool.

Sections
Tools
Relevant Parts
Image #1

Add Note Edit Step 1 — Battery  ¶ 

  • Use your fingers to push both battery release tabs away from the battery and lift the battery out of the computer.

Image #1

Add Note Edit Step 2 — RAM Shield  ¶ 

  • Remove the four identical Phillips screws from the memory door.

Image #1

Add Note Edit Step 3  ¶ 

  • Lift the memory door up enough to get a grip on it, and slide it toward you, pulling it away from the casing.

Image #1

Add Note Edit Step 4 — Upper Case  ¶ 

  • Remove the three Phillips screws in the battery compartment near the latch. Apple was nice enough to tilt these screws at a slight angle to make them easier to remove.

Image #1

Add Note Edit Step 5  ¶ 

  • Remove the following six screws:

    • Two T6 Torx screws on either side of the RAM slot.

    • Four Phillips screws along the hinge.

Image #1

Add Note Edit Step 6  ¶ 

  • Remove the four Phillips screws on the port side of the computer.

Image #1

Add Note Edit Step 7  ¶ 

  • Rotate the computer 90 degrees and remove the two Phillips screws from the rear of the computer.

Image #1

Add Note Edit Step 8  ¶ 

  • Rotate the computer 90 degrees again and remove the four Phillips screws from the side of the computer.

Next » « Previous

Required Tools

Spudger

$2.95 · 50+ In stock

T6 Torx Screwdriver

$4.95 · 50+ In stock

Phillips #00 Screwdriver

$4.95 · 50+ In stock

Related Products

MacBook Pro 17" (Model A1151) Left Fan

$49.95 · 10 In stock

MacBook Pro 17" (Model A1212) Left Fan

$49.95 · 10 In stock

Recommended Tools

Universal Drive Adaptor

$29.95 · 50+ In stock

iFixit Lock Pick Set

$29.95 · 14 In stock

Inspection Scope

$39.95 · 37 In stock

Frictionless Ratchet

$24.95 · 48 In stock

Portable Anti-Static Mat

$24.95 · 16 In stock

Comments Add Note Comments are offturn on