Gateway MD2614u Fan Replacement

Introduction

The fan to computers are used to keep laptops from overheating. This repair guide will cover the steps for to replace a fan to the gateway MD2614u laptop. This guide is perfect for you if you have faulty fan, which can be detected by either a warning on the laptop or if the laptop has constant overheating and slow response time. Ensure that the fan is the problem before proceeding with the guide below. Once you are sure that your fan is faulty and want to install a new fan, please ensure that your laptop is completely powered off and proceed the step by step guide.

What you need

Step 1 Back Cover

Gateway MD2614u Fan Replacement, Back Cover: step 1, image 1 of 1

Place the laptop so the back cover is facing up.

Edit

Step 2

Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

Edit

Step 3

Lift off the cover.

Edit

Step 4 Fan

Gateway MD2614u Fan Replacement, Fan: step 4, image 1 of 1

Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.
Pull the plastic part of the cable, not the wires, so that the plug does not break.

Edit

Step 5

Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.

Edit

Step 6

The fan is permanently attached to the silver heat sink next to the RAM.
To completely remove the parts, loosen the heat sink’s four screws with a Phillips #00 screw driver.
Take out the screws in the numerical order shown on the heat sink.