Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 1 Use a coin to rotate the battery locking screw 90 degrees clockwise. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s522 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 2 Lift the battery out of the computer. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s523 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 3 Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free. If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again. Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s528 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 4 If the computer has an AirPort card installed, follow the next three steps to remove it. Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s529 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 5 Grasp the clear plastic tab on the AirPort card and pull toward the display. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s530 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 6 Hold the AirPort card in one hand and use your other hand to remove the antenna cable. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s531 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 7 Remove the four silver Phillips screws that secure the RAM shield. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s532 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 8 Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s533 Installing iBook G4 12" 800 MHz-1.2 GHz Keyboard: Step 9 Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible. Make sure that you reconnect the keyboard cable before replacing the RAM shield. /Guide/Repair/iBook-G4-12-Inch-800-MHz-1-2-GHz-Keyboard/155/all#s534