Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 1 Use your fingers to push both battery release tabs away from the battery, and lift the battery out of the computer. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2235 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 2 Remove the three identical Phillips screws from the memory door. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2236 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 3 Lift the memory door up enough to get a grip on it, and slide it toward you, pulling it away from the casing. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2237 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 4 Remove the two Phillips screws in the battery compartment near the latch. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2240 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 5 Remove the following 6 screws: Two 10 mm T6 Torx screws on either side of the RAM slot. Four 14.5 mm Phillips screws along the hinge. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2241 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 6 Remove the four Phillips screws on the port side of the computer. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2242 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 7 Rotate the computer 90 degrees and remove the two Phillips screws from the rear of the computer. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2243 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 8 Rotate the computer 90 degrees again and remove the four Phillips screws from the side of the computer. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2244 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 9 Do not yank the upper case off quickly. The case is attached to the logic board via a ribbon cable. Lift up at the rear of the case and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2245 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 10 Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary. Remove the upper case. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2246 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 11 Lift the Bluetooth board out of its slot next to the hard drive and use a spudger to disconnect the Bluetooth antenna cable. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2320 Installing MacBook Pro 15" Core Duo Bluetooth Board: Step 12 Slide back the translucent plastic sheath to reveal the Bluetooth data connector beneath. Disconnect the orange data cable from the Bluetooth board by sliding the locking mechanism slightly to the right to free the cable, and then sliding the cable out of its connector. /Guide/Repair/MacBook-Pro-15-Inch-Core-Duo-Bluetooth-Board/494/all#s2321