Introduction
Use this guide to remove or replace the battery shell (AKA battery cover, rear cover) on your Analogue pocket.
What you need
-
-
Unplug all cables and fully power off your device.
-
Working on your device requires laying it screen-side down. To prevent damage, lay it on a soft surface such as a towel.
-
-
-
-
Use a T6 Torx screwdriver to remove the four 13.4 mm‑long screws securing the battery shell.
-
-
-
Lift the bottom edge of the battery shell to unhook its tabs.
-
Remove the battery shell.
-
Almost done!
To reassemble your device, follow these instructions in reverse order.
Conclusion
To reassemble your device, follow these instructions in reverse order.
