can anybody provide pinouts (dc voltages) from the 13" macbook unibody magsafe board, part number 820-2361-02. By this I mean I already know the voltages on the power connector, i am looking for the output voltages on the pins from the magsafe board in the plastic connector that attached to the logic board -- or any other way to figure out if the dc board is bad other than spending money on a new one I might not need.
Page 1 of 1
reply by
clueless1
Does anybody have a way to test the dc board to see if its working?
reply by
Michael
Anyone? I also want to check that the voltages I see at my DC-IN Board 5-pin internal connector are correct, though I have an A1181 MacBook. It will not charge or run from AC power. These are the voltages I see...
Starting from rear (screen-side) of logic-board:
1. Black: 17.12 V
2. Black: 0.00 V
3. Black: 0.00 V
4. Grey: 17.24 V
5. Grey: 17.24 V
reply by
Kyle Wiens
Try posting this question on Answers, you'll more visibility and a response there.