Skip to main content

Second generation of iPhone. Model A1241 / 8 or 16 GB capacity / black or white plastic back. Repair is more straightforward than the first iPhone. requires screwdrivers, prying, and suction tools.

1158 Questions View all

No USB Connection after I broke little SMD element near connector #4!

I can neither charge the iPhone nor connect it to iTunes. Nothing happens when the phone is connected to a USB/charging cable. If the iPhone is off, connecting a cable turn it on.

It seems I broke a little SMD element near connector4 of the logic board when I disconnected this connector with a screwdriver!!!

Does anybody know what type of SMD element that is and where I can buy it? It is so little that I lost it on my table and never find that part again!

See picture:

Block Image

Block Image

Update

I am having this problem, but I just checked my board and that SMD looks perfectly intact. What else could be? The connector 4 is firmly attached as well...

Answered! View the answer I have this problem too

Is this a good question?

Score 1
1 Comment

If you still have the mentioned SMD coil and your iPhone starts up when connected with usb charger it's another problem. Start you own question!

The coil filters the USB data lines. Maybe your line is broken on another point?

by

Add a comment

1 Answer

Chosen Solution

I found an answer myself:

This element is coil!

Connect like this:

Block Image

http://forum.gsmhosting.com/vbb/f631/iph...

Was this answer helpful?

Score 2

1 Comment:

It was the "NOISE FILTER COM MODE 90 OHM SMD" -> Digikey part number: P14216CT-ND. http://forum.gsmhosting.com/vbb/f631/iph... - Data Sheet here: http://industrial.panasonic.com/www-data... (Common mode Noise Filters, Noise reduction of high-speed data lines such as USB,

LVDS, and HDMI lines)

by

Add a comment

Add your answer

James Bond will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 13,030