Skip to main content

Model A1236 / 4 or 8 GB capacity

134 Questions View all

iPod nano 3rd generation stuck in"Use iTunes to restore" screen.

after I synced the ipod with my windows 7 laptop, the ipod, all of a sudden, turned off. Then it powered on and came to the "Use iTunes to restore" screen. When i connect it to the laptop, the ipod automatically enters into disk mode and while restoring, the ipod stays in the "do not disconnect" screen. After iTunes completes restoring, the message "Your iPod has been restored to factory settings, and is restarting. Please leave your iPod connected. It will appear in the iTunes window after it restarts." but after the ipod restarts, the same "use iTunes to restore" screen comes up and itunes detects it in recovery mode.

Please help me with this problem.

Answer this question I have this problem too

Is this a good question?

Score -1
Add a comment

1 Answer

Most likely a bad flash chip.

Was this answer helpful?

Score 0

1 Comment:

Should I replace it? How much would it cost?

by

Add a comment

Add your answer

tarunsrini will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 855