<?xml version="1.0" encoding="utf-8"?>
<rss version="2.0"
					xmlns:content="http://purl.org/rss/1.0/modules/content/"
					xmlns:wfw="http://wellformedweb.org/CommentAPI/"
				  >
<channel>
<title><![CDATA[iFixit - Active Questions Tagged idle]]></title>
<link>http://www.ifixit.com/Answers/Tag/idle</link>
<description><![CDATA[Questions with recent activity. Only showing questions tagged idle.]]></description>
<language>en-US</language>
<pubDate>Sat, 18 May 2013 23:26:41 -0700</pubDate>
<item>
<title><![CDATA[1997-2001 Jeep Cherokee: Won't Idle Correctly After Attempted Repair-What Next]]></title>
<description><![CDATA[<p>I have a 2000 Jeep Cherokee 4.0L ( XJ ) limited trim. It will not idle correctly. below the regular RPM or above..... i replaced the idle position sensor and had the IAC system reset by a friend who is a mechanic. ( idle sensor was to blame, to keep my question short). Everything seemed to be quite fine having done this yesterday. Even seemed to run better/stronger<wbr />.</p>

<p>Until this mourning when it would not idle at all.... until i started and held the gas down above idle speed for about 60seconds.  Also does not idle at a consistent speed and occasionally idles rough.</p>

<p>I will be doing a tune up over the weekend since it is due, which is fairly easy with no plug wires etc just the ignition pack over the plugs.</p>

<p>I am not sure if this will help with my current problem since the computer should correct within reason for any ignition timing if i had bad plugs? yea?</p>

<p>If anyone has any ideas? let me know. If i had a bad part in the ignition system it would throw a code? and the check engine light has yet to come on and everything checked out ok just yesterday.</p>

<p>⟐ Edited December  7, 2012 at  5:42 pm -0700</p>]]></description>
<link>http://www.ifixit.com/Answers/View/69056/Won%27t+Idle+Correctly+After+Attempted+Repair-What+Next</link>
<guid>http://www.ifixit.com/Answers/View/69056</guid>
<pubDate>Fri, 07 Dec 2012 17:42:43 -0700</pubDate>
</item>
<item>
<title><![CDATA[iPhone 3G: No Service or Very weak service when Idle]]></title>
<description><![CDATA[<p>I've an unlocked iPhone 3G with GSM connection. My iPhone 3G sometimes gets very good signal but if I put the phone idle for sometimes (half an hour, more or less) the signal keeps loosing and finally shows &quot;No Service&quot;. Then if i reboot it, then it gets full signal.</p>

<p>I've also noticed as long as I put the phone on my hand and it gets worm, there is no Signalling issue but when i left it idle, the problem occurs again.</p>

<p>⟐ Commented November 22, 2011 at  7:35 am -0700</p>]]></description>
<link>http://www.ifixit.com/Answers/View/70855/No+Service+or+Very+weak+service+when+Idle</link>
<guid>http://www.ifixit.com/Answers/View/70855</guid>
<pubDate>Tue, 22 Nov 2011 07:35:56 -0700</pubDate>
</item>
</channel>
</rss>